How to solve the problem of random flowers of Whole garment computerized flat knitting machine?- Tongxiang Qianglong Machinery Co., Ltd.

The computerized flat knitting machine will appear random flower phenomenon in the process of use. As a staff, how can we effectively solve the problem of random flower on the computerized flat knitting machine? Let's take a look at the specific solutions:

Whole garment computerized flat knitting machine——Random flower (Random needle selection)

1) Check to see if there is a pattern in the random pattern of the cloth, for example, the problem lies in the needle selector.

2) See if it is a stealing election or a missed election. Adjust the gap between the selector jacks and the needle bed.

3) Adjust needle selection parameters, needle selection origin, and needle selection fine-tuning.

4) Check whether the needle selection stitches are too tight or too loose on the needle bed. Is it smooth.

5) Check the circuit to see if the plugs are plugged in properly to see if there is any poor contact.

6) See if the main drive belt is too loose.

7) See if the needle gauge is too tight or too loose.

8) Replace the needle selector board.

9) Re-find the origin, the national flower series should pay attention to the copper head part.

Computerized Flat Knitting Machine - Measure

1) The stitches are getting bigger and bigger when weaving

A, check whether the circuit is in poor contact.

B. Check whether the screw of the stitch motor is loose.

2) Two stitches are woven at the same time. If one stitch becomes abnormally small, consider increasing the stitch origin.

There are many problems involved in the work of the computerized flat knitting machine, such as various knitting techniques, density adjustment, etc. The solution is to introduce to you the lateral movement of the computerized flat knitting machine:

The traverse movement of the needle bed of the computerized flat knitting machine

1. The principle of needle bed traverse: controlled by program and realized by stepping motor.

2. Needle bed traverse type and function:

(1) Full needle pitch traverse —— Through the full needle pitch lateral movement, the corresponding relationship between the needles and needles of the front and rear needle beds can be changed.

(2) Half needle pitch traverse - change the corresponding relationship between the needle grooves of the two needle beds, and the needle grooves can be changed from relative to needle grooves.

(3) Transfer and traverse - make the position of the needle grooves of the front and rear needle beds staggered by about a quarter of the needle pitch

3. Maximum traverse distance —— 50.8㎜～101.6㎜ (2 inches-4 inches)